Keep your hot water pressure washer's exhaust system running cleanly with the 10" Draft Diverter. Designed to fit standard stove pipe, this heavy-duty accessory prevents backdrafts that can disrupt burner performance, blocks cold air from cooling your vent stack, and stops rainwater from running down the pipe into your burner assembly.
Built from hot-dipped galvanized steel, the diverter is engineered to withstand the heat, moisture, and outdoor exposure that come with commercial pressure washer installations. Whether your equipment is venting through a roof, a wall, or an outdoor housing, the draft diverter protects the burner from the elements and helps your washer fire reliably every time you pull the trigger.
Key Benefits
- Prevents backdrafts that can disrupt burner ignition and shorten component life
- Blocks cold air infiltration that wastes fuel and slows heat-up times
- Stops water intrusion down the vent pipe, protecting the burner and coil
- Hot-dipped galvanized construction resists rust and corrosion in outdoor environments
- Slips onto standard 10" stove pipe — no special tooling required
Best For
Commercial and industrial users running hot water pressure washers in environments where weather, wind, or vent routing can compromise burner performance. A smart, low-cost addition to any oil, natural gas, or LP-fired washer installation.
